|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-15-2021, 10:59 PM
|
#25 |
|
Mr. Cheyenne
  
Join Date: Jun 2020
Location: Kyle, Texas
Posts: 1,647
|
Re: Blowing "Tail Stop Park Dome" fuse w/ Brake On Then Left Turn Signal
btw, my new harness did fix my fuse getting blown. though I'll need to replace it again since when I turn on my hazards my rear brake lights will not flash (they will turn on fully if I am actively pushing in the red switch). GMCPauls opinion they are fully tested, never leave non-operational and they are a electrical part, so no replacement offered. It is what it is - my biggest problem is taking it all a part again LOL (actually cry laughing).
I didn't figure this out until a wrench fell out from under my hood (opps) when driving the to corner store a few days after the install. I had to pull into the center lane and run back to get my darn wrench! When running back to my truck I said to myself, why the F are my back lights not flashing!!!
__________________
Richard '72 Chevy C10 Cheyenne *Super WHT/MED BRONZE/WHT SBC 350 | TH350 | LWB | AC | Buddy Seats Upgrades: Tilt | Front Sway Bar | Radio | Sliding Window | Bed Spare w/Lock Bed Rails | Full LEDs | Courtesy Lights | Tachometer | Glovebox Lock & Light | Head Light Relays | *Upgraded Fully Super Trim |
|
|
| Bookmarks |
|
|
Threaded Mode